Sound menu: Revised Tone-Wheel Vintage settings and addition of "Vintage 4" option:
The new Vintage 3 corresponds to the previous Vintage 2 setting, but with a revised character
The new Vintage 2 setting provides leakage that has its focus lower in the frequency range as compared to Vintage 3
The new Vintage 1 setting is similar to Vintage 2, with less sub-fundamental leakage
The new Vintage 4 setting is similar to Vintage 3 but with a more pronounced effect
Improvements to Farfisa compression
Soft B3 Organ Model now always uses Vintage 1 Tone-Wheel character (or Clean, if that is selected in menu)
Fixed bug where Analog Mode for Delay could not be activated using standard Shift operation, but only by using "hold to Shift"
v0.98 (2025-10-23)
FX Bypass for Bass Pedals removed the pedal sound from the 11-pin/High Level outputs. Fixed
The Bass Pedals can, if desired, be removed from both the 11-pin/High Level and L+R outputs by setting the Aux Output to Breakout > Bass Pedals.
The “Rotary Bass” setting for the Aux output now removes the Rotary Bass speaker sound from the L+R outputs and has been renamed to Breakout > Rot. Bass. This keeps only the treble horn sound on the L+R outputs.
Certain external Rotary Speaker units did not receive audio on the 11-pin output, due to not being detected by the sensing mechanism. Fixed
The menu options for the Output Routing pages have been revised. The available settings now are:
Increased resolution for treble horn and bass rotor models
Improved cross-over filter characteristics, with more pronunced resonances in certain ranges
Updated bass rotor sound with a slightly extended treble range
Fixed a number of parameter texts and hints
v0.94 (2025-06-10)
Fixed "Stop Angle" is now implemented as intended. • To activate the fixed Stop Angle, press Shift+Rotor Speed Stop (or hold down the Stop button). The Stop LED now blinks when the rotor is stopped. • To set the angle, open the Sound Menu (Shift+Live 3), navigate to page 4 and select Stop Mode. Use the dial to select the angle. • Depending on Mic Pos selection, the L+R mic indicators will change in the display.
Unified L+R channel positioning for all Mic Positions
Pressing Store no longer enters “pre-listen” for the current program, to avoid abrupt changes in sound when storing a program (unless a different Program location is selected)
B3 Init (Shift+Organ Model) now initializes the B3 panel parameters (Chorus/Vib, Percussion) and Bass Pedal options as well.